[3D] grigorusha Kaleidoscope Ball (DLP 3D-Printing) [复制链接]

Rank: 8 Rank: 8

发表于 2019-5-17 00:53:07 |显示全部楼层

I present my New puzzle - Kaleidoscope Ball
I took this name because in a confusing way the puzzle looks like a kaleidoscope !!
This is a sphere, 4 axes, the angle of rotation is 60 degrees. many elements can block turns, you can probably say that this is a bandaged puzzle. diameter: 60mm

Shop: http://www.grigorusha.com

This puzzle is done in two days (quick development) on my home 3D-printer
See this thread "Home made puzzles using DLP 3D Printer" - http://twistypuzzles.com/forum/viewtopic.php?f=9&t=33909

I got the idea of the puzzle thanks to the Gelatinbrain simulator - this is the SPHERE 631.

There are several similar puzzles:
1) DDR's Super Pyraminx Ball - 3d sketch of a similar puzzle, it is a pity that it was not finished.
http://twistypuzzles.com/forum/viewtopic.php?f=15&t=25589
2) DDR's Super Pyraminx - This is a pyramid-shaped version, with same as cuts.
http://twistypuzzles.com/forum/viewtopic.php?f=15&t=25580

also
1) SPHERE 612 - cube geometry.
http://twistypuzzles.com/forum/viewtopic.php?f=15&t=25581
2) SkyGlobe - this is a completely unbadaged version of my puzzle.
http://twistypuzzles.com/cgi-bin/puzzle.cgi?pkey=1790
3) Split Jings Pyraminx - This is a pyramid-shaped version, but here is a deeper cuts.
http://twistypuzzles.com/cgi-bin/puzzle.cgi?pkey=3402