日本小子的中心块调整工具

老猫

M6 board nut

It becomes an applied part where the central core side is suppressed by previously installing it about the main bolt.

老猫

- It assembles it as follows. (^^)
Though fine-tuning is also slightly necessary ･･･ It does by rule of thumb. (^^;

老猫

Whole chart

老猫

Back

老猫

From former

老猫

From post-

老猫

The order of how to assemble it fine-tunes L character metal fittings (largeness) while setting central parts though it is not especially.
After that, it ..board nut (.. fixes with the instant adhesive etc. though *) is installed in the point of the main bolt.

[此贴子已经被作者于2006-3-9 15:47:20编辑过]

老猫

老猫

First of all, both sides of a central cube are pulled. ｢The expansion condition is ..encounter.. ..,.. becoming it certainly different. ^^;｣It confirms. Is it the one that manages not to become though is so if it is said it is reluctant because and a central bolt are the driving types?..(.. ..cry..)
Beforehand as such, it thinks where how much is pulled out at this time. How much?.....Suitably. (^^; There is Moromoro though it actually expresses numerically.

老猫

L character class

L character metal fittings (smallness) are united as shown in the above figure. Only one side is fixed at this time so that opening and shutting is possible. The tightening condition is also suitable. (^^;

[此贴子已经被作者于2006-3-9 15:49:54编辑过]