日本小子的中心块调整工具

老猫

L character class is set.

L character class is set in central parts as shown in the above figure. The purpose of this is to widen the bearing area of *) ..board nut (...

老猫

- Central parts that set L character class are set in the central adjustment tool.

Pulled central cube, main body of central parts, L character classes, L character metal fittings (largeness), and board nuts
How a central cube is pulled when the position is seen can be understood ･･･.
.｡｡(^^;

[此贴子已经被作者于2006-3-9 15:52:15编辑过]

老猫

- Then, the center is adjusted.
It becomes the work of sober Japanese syllabary-. (^^;

A hex-head wrench that turns the main bolt is prepared. It is an easy Chin duck when there are two kinds as showing in the photograph.

老猫

It is easy to turn even if the angle has adhered because a hex-head wrench of the driver type is a type to which the point has rounded.

老猫

It is Shicnesgage. It is a tool to measure the area of the space chiefly. The numerical value doesn't serve as a reference slightly in Barebare. (^^;

老猫

It is Spana to tighten the hex nut. Any one is O.K . However, the thin one is good as such.

老猫

The entire how to take a stance becomes such feeling. Spana is turned by the right hand with the whole by the left hand actually.

老猫

Botiboti clears up in Spana while fixing the main bolt with a hex-head wrench when tightening it and a central cube is pulled. (^^)

老猫

Six corner nut that encounters and is trained to the main bolt of two , is tightened taking the place alternatively little by little with Botiboti. When only one side is tightened at a dash, it is dangerous. (^^;

老猫

Then, it becomes anyway the same pull omission condition as six by using Shicnesgage. Any measurement tool is good because the thickness pulled out is decided when doing. (^^)