grigorusha Bi-Linked Cube (DLP 3D-Printing)
本帖最后由 grigr 于 2019-7-6 18:04 编辑I previously showed my Linked Cube set, but then I made only versions with one linked chains.
Those who bought an extended version of Linked cube or Joint cube will be able to make this puzzle.
This is a very unusual find - Bi-Linked Cube !!!
the principle is the same - the linked chains cannot be broken. but in this cube there are two such linked chains!
Because of this, each rotation of the face requires special additional steps. my opinion is very difficult to solve !!!
visit my Store: http://www.grigorusha.com
Video:
Bi-Linked Cube v1 - 2+2 Lines
本帖最后由 grigr 于 2019-7-6 18:06 编辑
also I made
Bi-Linked Cube v2 - 2+3 Lines
Great!May be Tri-link or Quad-link is possible too! xwfh2000 发表于 2019-7-8 04:07 static/image/common/back.gif
Great!May be Tri-link or Quad-link is possible too!
no. this is not turnable
页:
[1]