grigr 发表于 2019-7-6 16:12:05

grigorusha Linked Cube Plus (DLP 3D-Printing)

本帖最后由 grigr 于 2019-7-6 11:13 编辑

I previously showed my Linked Cube set.
At first I did not want to add additional elements here (I have a few additional parts from the kit Edge Confusion Cube).
In the original design of the Linked Cube, the inability to create a closed rings from linked chain - this chain will completely block all turns.
I decided to experiment with adding from a shortened edge, because this part allows you to create and open closed rings!
It also turned out that this part could break away from the main linked chain, and then return to it.
I am very pleased that the puzzle has received a lot of additional properties. My opinion is a very difficult solution process !!!

visit my Store: http://www.grigorusha.com
Video:

Linked Cube Plus v1 - 3.5 lines







--------------------------------------------------
Linked Cube Plus v2 - 5.5 lines






页: [1]
查看完整版本: grigorusha Linked Cube Plus (DLP 3D-Printing)